Advertisement

Your hot water system installation, whether a gas heater or an electric heater, is destined to make a steady supply of hot water for your home.

If you are living in a region where winters can go below freezing point, even the water at room temperature might feel too cold. Having a hot water system at home ensures you have access to hot water whenever needed.

The hot water system installation process might be simple and easy with a simple process to follow. However, it is when you actually try to follow up with the process that you realize how many mistakes you have made.

However, you don’t have to worry about that anymore. Today, we are here to help you and highlight the most common mistakes so that you can avoid them when installing a hot water system.

Installing Hot Water SystemL Mistakes To Avoid

Bathing with hot water is beneficial for your body, especially when you come home after a long day at work. But to get that hot water, you need to install a hot water system first.

Most people try to DIY hot water system installation and make mistakes which only increases the expenses. If you have never installed a hot water system, it is advisable that you seek help from professionals.

However, if you are stuck on doing it yourself, ensure that you avoid making these mistakes.

Mistake 1: Improper Soldering Of Pipes

One of the most common mistakes we have seen people make while installing a hot water system is during the soldering of the pipes. The installation process needs to solder the pipe close to the tank to establish a connection. But, most people solder it too close to the tank.

Now, you must be wondering why this is a problem. Well, the problem is that the water tank has too many plastic fittings. So, when the propane torch gets too close to these plastic fittings, they are melted and destroyed.

Mistake 2: Improper Installation Of Relief Valve

Whether you are using a smart hot water system or a traditional hot water system, relief valves are the safety features that help control the pressure and temperature of the water. If this essential piece is not careful, the water tank can explode.

You will notice that a relief valve is located a couple of inches above the floor. This offers an automatic mechanism to relieve additional pressure. To ensure your protection, connect a threaded drain tube along with the outlet. This tube will direct any unexpected discharge in the direction of the floor.

Mistake 3: Avoid Dry Firing

Once you have completed the installation process, it is important that you don’t turn on the circuit until the heater is completely filled with water. Once the installation is complete, ensure that you purge out all the water inside the heater to have an uninterrupted hot water flow.

If you don’t purge the air from inside the heater, when you turn on the heater, the water will become hot and come out in the form of steam. As a result, you might get some serious burns.

Mistake 4: Avoiding Insulation

Insulation is important. Insulating your water heater and hot water pipes can reduce energy consumption.

Insulation helps the water inside the heater stay warm for a longer period. This means you need less energy every time you turn on the water heater.

Skip The Trouble, Go Straight To Professionals

Though some handy homeowners are capable of safely installing a hot water system, it is a job that can quickly go awry if you’re not careful with the installation process. It exposes not only you but also your family to the risk of injury.

Why not save yourself effort and risk by calling for professionals like LiVESG?

These hot water system experts have more than a decade of experience and know what they are doing. They have installed and repaired countless hot water systems and know what it takes to complete this job safely.